Heater Not Working? How to Troubleshoot at Home

If you are a homeowner, you should know about your heating system. Your knowledge regarding the heating system will help you troubleshoot issues confidently. DIY troubleshooting at home can save you money and time. In order to ensure it is kept in the best condition, opt for on-time furnace service in Roswell, GA. Now, let us learn some tips to restart your heating system at home.

Troubleshoot Your Heating System at Home in The Following Ways

• Ensure The Thermostat Is Set to Heat

You should start with the thermostat to troubleshoot the furnace. In the winter, the thermostat should be set to the Heat setting.

Apart from this, you can also inspect the wire that connects the thermostat to the furnace. If you find any break, you should repair it immediately or call for a professional HVAC contractor in Duluth, GA.

• Check the Condition of the Filters.

If the furnace filters get clogged with dirt and debris, your heating system will incur a high operational cost. Even the heat exchanger can quickly overheat and shut down the furnace faster than expected. Professional furnace installation in Duluth, GA, advises checking and replacing the filters if there is no heat from the system.

However, if you have a flat filter, you should inspect it every month, and in the case of pleated filters, inspect it at least every three months.

• Inspect the Air Ducts for Blocked Vents

You may not realize this sooner, but the problem of blocked vents can prevent the furnace from operating appropriately. As a result, heat distribution will not be equal in your house. Some vents must remain open for the air to flow back and forth. In this way, the system can provide adequate temperature for your rooms.

You should investigate whether any vents are clogged. If this is the case, try to unclog the vents as much as possible, or call an expert furnace repair in Roswell, GA, for assistance.

• Ensure the Gas Line Is Turned On

The furnace system has a separate switch for the gas line. The system can run when the gas supply is turned on. You ought to inspect it. If this is the case, the furnace will not generate heat. You can avoid this situation by turning on the switch and ensuring it doesn’t happen again. You may contact your reliable furnace installation in Alpharetta, GA, for further support.

To Summarize,

By understanding these DIY methods, you can try to repair your heating system. However, for issues that are too complex, call for an expert for HVAC repair in Suwanee, GA.

JE Mechanical HVAC is a reputable HVAC service provider with years of experience. Call us at 470-239-1411 to learn about our offers and services.

Recent Posts